Additional
Information
85
Troubleshooting
filename[01GB08ADD-NP0.fm] model name1[SLV-SE850G (ENG)] model name2[]
[3-062-332-
11
(1)]
Power
S26
POWER SAVE is set
to ON but the display
remains lit in
STANDBY mode.
t
The display is always lit if the VCR is in timer standby mode. For
more details regarding the energy saving function, see page 75.
Tape
S27
The tape is ejected
when you press
?
/
1
ON/STANDBY.
t
You have set a timer recording, but the tape on which you want to
record is protected. Use another tape or replace the safety tab.
S28
A tape cannot be
inserted.
t
Check that a tape isn’t already in the tape compartment.
SMARTLINK
S29
The SMARTLINK
function does not
work properly.
t
Check that your TV complies with SMARTLINK, NexTView Link,
MEGALOGIC, EASYLINK/CinemaLink, Q-Link or TV-LINK.
t
Make sure you use a 21-pin Scart cable to connect the VCR and your
TV.
t
Make sure the Scart cable is connected securely. Refer to your TV
manual for instructions.
Set-Top Box
control
S30
The Set-Top Box
Control function
does not work
properly.
t
Be sure to point the VCR remote commander only at the VCR’s
remote sensor and not at the STB sensor.
t
Be sure the STB controller is pointing at the set top box’s remote
sensor receiver.
t
Make sure the STB controller is connected securely.
t
The STB tuner brand number may be deleted if you disconnect it
from the VCR. Re-enter the brand code number corresponding to your
set top box (see page 28).
S31
You cannot watch the
STB picture when
the VCR is in
standby mode or
z
REC standby mode.
t
Make sure the POWER SAVE option is set to OFF in the OTHER
OPTIONS menu (see page 75).
