36
Appendices
product or remove the “Memory Stick.” This may damage the
data.
About a “Memory Stick”
• When you set the “Memory Stick” write-protect tab to
“LOCK,” data cannot be recorded, edited, or erased.
• Data may be damaged if:
— You remove the “Memory Stick” or turn off the unit while
it is reading or writing data.
— You use the “Memory Stick” in a location subject to the
effects of static electricity or electric noise.
• We recommend that you make a backup copy of important
data that you record on the “Memory Stick.”
• Do not attach anything other than the supplied label to the
“Memory Stick” labeling position.
• Attach the label so that it does not stick out beyond the
labeling position.
• Carry and store the “Memory Stick” in its case.
• Do not touch the terminal of the “Memory Stick” with
anything, including your finger or metallic objects.
• Do not strike, bend, or drop the “Memory Stick.”
• Do not disassemble or modify the “Memory Stick.”
• Do not allow the “Memory Stick” to get wet.
• Do not use or store the “Memory Stick” in a location that is:
— Extremely hot, such as in a car parked in the sun
— Under direct sunlight
— Very humid or subject to corrosive substances
Precautions
• To prevent data loss, make backups of data frequently. In no
event will Sony be liable for any loss of data.
• Unauthorized recording may be contrary to the provisions of
copyright law. When you use a “Memory Stick” that has been
pre-recorded, be sure that the material has been recorded
in accordance with copyright and other applicable laws.
• The “Memory Stick” application software may be modified or
changed by Sony without prior notice.
• Note that there are certain restrictions on recording stage
performances and other entertainment events, even if they
are recorded for personal use only.
Specifications
Notes
• “Memory Stick” and are trademarks of Sony Corporation.
• “Memory Stick Duo” and are trademarks of
Sony Corporation.
• “Memory Stick PRO” and are trademarks
of Sony Corporation.
• “Memory Stick PRO Duo” and are
trademarks of Sony Corporation.
• “MagicGate” and are trademarks of Sony
Corporation.
Terminal
Write-protect tab
Labelling position
General
Power requirements 180 V DC, 1.0 A (max.)
12 V DC, 7 A (max.)
Operating temperature −10°C to +45°C (14°F to +113°F)
Storage temperature −20°C to +60°C (−4°F to +140°F)
Mass Approx. 4.4 kg (9 lb 11 oz) (camera
head only)
Imager
Imager 2/3-type Progressive Scan CCD
Method 3-CCD, RGB
Effective resolution 1920 (horizontal) × 1080 (vertical)
Electrical characteristics
Sensitivity f10.0 with 59.94 Hz/f11.0 with 50.00 Hz
(at 2000 lx with 89.9% reflectivity)
Image S/N HD output: Typical −55 dB
SD output: Typical −65 dB (59.94 Hz)
Typ ical −63 dB (50.00 Hz)
Horizontal resolution HD: 1000 TV lines (at center of screen)
5% or higher modulation
Geometric distortion Negligible (not including lens distortion)
Optical system specifications
Spectral system F1.4 prism
Built-in filters ND filters
1: Clear
2: 1/4 ND
3: 1/16 ND
4: 1/64 ND
Input/output connectors
CCU Triax connector (1)
LENS 12-pin (1)
VF 20-pin (1)
MIC 1 IN XLR 3-pin, female (1)
AUDIO IN CH1, CH2 XLR 3-pin, female (1 each)
For MIC: −60 dBu (variable up to −20
dBu by menu or HXCU-100 operation),
balanced
For LINE: 0 dBu, balanced
INTERCOM XLR 5-pin, female (1)
EARPHONE Stereo minijack (1)
DC IN XLR 4-pin (1), 10.5 to 17 V DC
DC OUT 4-pin (1), 10.5 to 17 V DC, 0.5 A
maximum
It may be limited depending on the load
and input conditions.
SDI BNC type (1)
TEST OUT BNC type (1)
PROMPTER/GENLOCK/
RET
BNC type (1), 1 Vp-p, 75 ohms
RET CTRL 6-pin (1)
REMOTE 8-pin (1)
TRACKER 10-pin (1)
