Chapter 9 Maintenance and Troubleshooting
117
9-3 Alarms
a) With respect to setting of basic menu item 016
During playback
a) With respect to setting of basic menu item 016
During front panel operations
FORMAT NG! off Automatic format failed. Use another disc.
DISC ERROR! limit A disc error occurred during write back.
Data could not be recorded normally.
Try ejecting the disc and inserting it again,
or insert another disc.
DI read err off A disc read error occurred. Try ejecting the disc and inserting it again,
or insert another disc.
DRV ADJ err off Adjustment processing failed when a
disc was inserted.
Message in time
data display
Display
condition
a)
Description Action
Message in time
data display
Display
condition
a)
Description Action
525/60 Disc limit An attempt was made to play back a disc
recorded with the NTSC system when
this unit is in 625 line mode (PAL
system).
Use a disc recorded with the PAL system.
625/50 Disc limit An attempt was made to play back a disc
recorded with the PAL system when this
unit is in 525(U) or 525(J) line mode
(NTSC system).
Use a disc recorded with the NTSC
system.
No Support! off A disc recorded in an unsupported
recording format was inserted.
Use a disc recorded in the MPEG IMX or
DVCAM format.
Disc Error! off Normal playback is not possible because
of a disc defect.
Use another disc.
You can check the state of a disc by
checking playback condition marks (see
page 44).
Message in time
data display
Display
condition
a)
Description Action
KEY INHI.! on An operation button inhibited by
extended menu item 118 “KEY INHIBIT”
was pressed while the KEY INH
indicator was lit.
Set the corresponding sub-item of
extended menu item 118 to “off.”
See 8-3-2 “Extended Menu Operations”
(page 102) about how to make this setting.
REMOTE! on A button was pressed while the remote
control switch was set to “REMOTE.”
To operate from the front panel, wait until
control by the remote device ends and then
set the remote control switch to “LOCAL.”
No Disc! on A button was pressed with no disc
loaded.
Operate after inserting a disc.
No Disc! off An attempt to delete a clip was made
with no disc loaded.
No Disc! off An attempt to format a disc was made
with no disc loaded.
REC INHI.! on An attempt was made to record, display
an E-E picture, record an essence mark,
or add a quick scene selection sub clip.
To perform these operations on the disc,
set the write-protect tab of the disc to the
recording enabled position.
REC INHI.! on An attempt was made to record, display
an E-E picture, record an essence mark,
or add a quick scene selection sub clip
while extended menu item 310 “REC
INHIBIT” was set to “on.”
To perform these operations, set extended
menu item 310 to “off.”
See 8-3-2 “Extended Menu Operations”
(page 102) about how to make this setting.
