8
Setting up the remote commander
filename[01GB04GET-NP0.fm] model name1[SLV-SF990G(ENG)] model name2[]
[3-062-324-
11
(1)]
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the table below, set the appropriate manufacturer’s code number.
* These buttons may not work with all TVs.
Tip
• When you set your TV’s code number correctly while the TV is turned on, the TV turns off
automatically.
1
Set TV/VIDEO at the top of the remote commander to TV.
2
Hold down
?
/
1
, and enter your TV’s code number(s) using the programme
number buttons.Then release
?
/
1
.
Now you can use the following TV control buttons to control your TV:
?
/
1
, TV/VIDEO, programme number buttons, –/– – (ten’s digit), PROG +/–,
2
+/–,
a
(TV),
/
(Teletext), FASTEXT buttons, WIDE
*
, MENU
*
, CURSOR
M
*
/
m
*
/
<
*
/
,
*
, and OK
*
.
