74
Your camera cannot delete
an image.
•
The image is protected.
t
Cancel the protection (page 59).
The power turns off
suddenly.
•
If you do not operate the camera for about three
minutes while the power is on, the camera turns off
automatically to prevent wearing down the battery
(page 11).
t
The auto-power off function (page 11) is
activated. Turn on the camera.
•
The battery is discharged.
t
Replace it with a charged battery or new
alkaline batteries.
A file error occurs when
you play back a file.
•
The image size is larger than 1216×912.
The picture is
monochrome (black and
white).
•
The camera is set to TEXT mode.
t
Cancel TEXT mode (page 47).
•
P. EFFECT is set to B&W mode.
t
Cancel B&W mode (page 52).
Your personal computer
does not recognize your
camera.
•
The battery level is low.
t
Use the AC power adaptor (not supplied)
(page 14).
•
The camera is turned off.
t
Turn on the camera.
•
The USB cable is not connected firmly.
t
Disconnect the USB cable, and connect it again
firmly. Make sure that “USB MODE” is
displayed on the LCD screen (pages 31, 33).
•
The USB connectors on your personal computer are
connected to other equipment besides the keyboard,
the mouse, and your camera.
t
Disconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
•
The USB driver is not installed.
t
Install the USB driver (page 31).
•
[USB CONNECT] is set to [PTP] in the setup
settings.
t
Set it to [NORMAL] (page 66).
•
Since the camera is connected to a computer with
the USB cable before installing the USB driver, the
drive is not recognized by the computer.
t
Delete the drive which is not recognized, then
install the USB driver. For details, see the
procedure on page 76.
Symptom Cause and/or Solution
