ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC S SERIES TREADMILL. Assembly procedures
are the same for all S SERIES TREADMILLS.
UNPACKING
Open the shipping carton, remove all parts from the carton and foam inserts, and verify that the following parts are included
in your shipment:
Description Qty
Base Assembly 1
Neck (and Shroud) 1
Neck Shroud 1
Display Console Assembly 1
Handrail 2
Bolt, Allen Head, M10 X 20 8
Description Qty
Lockwasher, D=10 8
Hex Nuts* 4
Bolt, Allen Head, M6 X 50 4
Screw, Hex Head, M10 X 140** 4
Bolt, Allen Head, M6 X 25 2
Lockwasher, D=6 4
*Used for shipping only.
**Pre-installed on base assembly.
TOOLS REQUIRED
Most STAR TRAC treadmills can be assembled using the following tools:
• Metric Hex Key Wrenches
• Metric Open-End Wrenches
• Metric Ratchet Socket Wrench Set
• Torque Wrench
• Channel Lock Pliers
• Vice Grip Pliers
• Rubber Mallet
• Phillips Head Screwdriver
Your STAR TRAC S SERIES TREADMILL includes a hex key set and combination open-end wrench.
ASSEMBLY
1. Unpack and Position the Base Assembly
CAUTION: The motor end of the base assembly is very heavy. Two people may be needed to lift this end when moving
the base assembly.
Remove all packaging material so the base assembly is sitting on the shipping crate platform. With a helper, lift the
base assembly from the shipping crate platform, and place it in the location where it will be used. Be sure the
selected location is level, and close to a power outlet.
3. Install the Display Console
