Getting Set Up
30
Phaser 840 Color Printer
Macintosh software
Before you begin
Make a note of the following information and refer to it during the on-screen
installation procedure.
■ What is your printer’s configuration? Look on the printer’s Startup
Page under Feature Set:
Feature Set Select this driver:
Standard Tektronix Phaser 840
Plus Tektronix Phaser 840 Plus
Extended Tektronix Phaser 840 Extended
Startup
Printer Name:
Page Count:
Serial Number:
Adode® PostScript®:
Firmware:
Feature set:
Installed RAM:
ROM Fonts Available:
IDE Disk:
SCSI Disk:
Print Quality:
TekColor® Correction:
Parallel Port:
Ethernet®:
EtherTalk®:
NetWare®:
TCP/IP:
Phaser Swift
504
Ip3-63
OS 1.14 / PS 8.23 / Eng 8.51 / Net 5.55
Plus
128 MBytes
164 Fonts
2067 MB total, 2001 MB free
Not Connected
Enhanced
Automatic
Language:Postscript®
Protocol:Binary
Handshake: Bi-directional
PhaserShare® Series B Built-In Ethernet® Interface
10BASE-T, 08:00:11:08:59:53
LaserWriter@WV 60/61, Node ID: 5000.200
Operating Mode: Print Server (TEK085953)
Connection Mode:NDS (No Preferred DS Tree)
Networks: 0(802.2), 98 (802.3), 0 (Ethernet ll), 0 (SNAP)
Status Message: Can't find NDS tree, will retry in 60 sec
Address: 134:62:91:178
Network Mask: 255.255.255.0
Gateway: 134:62:91:1
Broadcast: 134:62.91.255
IPAddress Source: Front Panel
Phaser
®
840 Color Printer
Adobe Systems Incorporated which may be
ANTONE® and PANTONE CALIBRATED are trademarks of Pantone, Inc.
0389-40
Printer Name:
Page Count:
Serial Number:
Adode® PostScript®:
Firmware:
Feature set:
Installed RAM:
ROM Fonts Available:
IDE Disk:
SCSI Disk:
Print Quality:
TekColor® Correction:
Phaser Swift
504
Ip3-63
OS 1.14 / PS 8.23
Plus
128 MBytes
164 Fonts
2067 MB total,
20
Not Connected
Enhanced
Automatic
