A SERVICE OF

logo

C605 and C604 (Preliminary Information)
1-9
Introduction to the MSP50C614
Figure 1–3. RESET Circuit
Reset
Switch
1 µF
(20%)
Inside the
MSP50P614
MSP50C614
V
DD
V
SS
100 k
IN914
5 V
V
PP
To Pin 1 of Optional (Scanport)
Connector
RESET
1 k
To Pin 2 of optional (scan port) connector
IN914
(MSP50P614 only)
If it is necessary to use the software development tools to control the MSP50P614 in application board, the 1 k resistor is need-
ed to allow the development tool to over drive the RESET circuit on the application board.
This Diode can be omitted (shorted) if the application does not require use of the scanport interface. See Section 7.1.1 regarding
scan port bond out.