Titan Tool 292003 Manual

next previous

Cleanup

When cleaning the electrostatic system, these

safety procedures must be followed. Failure to

follow these procedures may result in an

explosion/fire

 • Turnpowerpacktothe“OFF”positionandunplug

from power source before starting to clean.

 • Becertainthatgun,cable,andpowerpackarefreeof

all paint spots and cleaning agent residue.

 • Exhaustandfreshairintroductionmustbemaintained

during the clean up operation.

 • Keepcleaningsolventsinapprovedsafetycontainers

and only in minimum quantities.

 • Allpersonnelandcleaningequipment,including

container used in cleaning operation, must be

grounded.

 • DONOTturnontheVM200powerpackuntilthe

cleaning operation has been completed, all cleaning

materials have been removed from spray area, and

spray area is free of any vapors produced by the

cleaning operation.

 • Ifdefectsintheequipmentarefound,DONOTuse

until repairs are completed.

 • Cleanequipmentimmediatelyafteruse.

 • NEVERIMMERSESPRAYGUNINANYFLUIDATANY

TIME.

 • Flushoutuidpassageswithacleaningsolvent

compatible with the coating material being sprayed

after each use.

 • BesuretheVM200PowerPackisturnedoffand

unplugged from the power source.

 • Checkthecoatingmanufacturer’srecommendation

for a compatible cleaning solvent.

NOTE

 • Theuidpassagesofthespraygunshouldbe

cleanedwhilealsocleaningtheuidhoseanduid

pump.Followtheinstructionsprovidedwiththeuid

pump.

 • Cleanthespraytipandaircapbyremovingfrom

spray gun, rinsing in solvent, drying and replacing on

spray gun.