Elite
E15
Pump Only -- 762-502
Complete -- 762-500
Hose
Rack
Pressure
Adjustment
Knob
Electrical
Box
Paint Filter
Bypass Valve
General Repair & Service
Notes:
WARNING: Before proceeding, follow the Pressure
Relief Procedure
outlined on page
3.
Additionally,
follow all other warnings to reduce the risk
of
an
injection injury, injury from moving parts
or
electric
shock. Always unplug the sprayer before servicing!
The following tools are needed when repairing this
sprayer:
Phillips Screwdriver
Needle Nose
Pliers
Adjustable Wrench
Rubber
Mallet
Flatblade Screwdriver
1/2"
Open End Wrench
3/8"
Allen Wrench
5/16"
Allen Wrench
1/4"
Allen Wrench
3/16"
Allen Wrench
1 /8"
Allen Wrench
1. Before repairing any part of the sprayer, read the
instructions
carefully, including all warnings.
2.
When· disconnecting wires, use needle nose pliers to
separate mating connectors.
3
230V Pump Only
--
762-238
230V Complete --762-240
Folding Handle
Frame Knob
Electric Motor
Add
P.S.L. Here
NOTE:
Repacking Kit 762-175 is available.
All
parts included in the Kit are marked
with
a
II
~
II
in parts
list
chart on page
24.
For
best results use all parts and tools supplied
in the Repacking Kit.
CAUTION: Never pull
on
a wire
to
disconnect it.
Pulling
on
a wire could loosen the connector from the
wire.
3.
Test your repair before regular operation of the
sprayer to be sure that the problem is corrected.
If the
sprayer does not operate properly, review the repair
procedure
to
determine if everything was done
correctly. Refer to the Troubleshooting Charts to help
identify other possible problems.
4.
Make certain that the service area is well ventilated
in case solvents are used during cleaning. Always
wear protective eyewear while servicing. Additional
protective equipment may be required depending
on
the type of cleaning solvent. Always contact the
supplier of solvents for recommendations.
5.
If
you
have any further questions concerning your
TITAN Airless Sprayer, call TITAN Customer Service
Department at 1-800-526-5362.
