© Titan Tool Inc. All rights reserved. 31
SAE O-Ring Fitting Installation
Steps 1 & 2:
Step 3:
Step 4:
Step 5:
Cautions:
Lubricate
Lubricate
Tighten nut
Recess
gap
No gap
Align
Hold
this part
stationay
Avoid screwing fitting in too far.
Avoid leaving fitting too far out.
Bent washer allows
for o-ring extrusion
O-ring cut on
thread
1. Pull washer and
o-ring back as far as
possible.
2. Lubricate o-ring and
entrance port.
3. Screw tting in until
washer pushes o-ring
into entrance and sits
at against port. (Do
not tighten! - only do
this step hand tight to
compress o-ring into
port!)
4. Back tting out
no more than one
complete turn to align
as required.
5. Torque nut wrench
tight holding backup
on tting. This should
expose a recess
gap behind the nut
which can act as an
indicator that the
tting is assembled
correctly. (This is a
feature for a specic
version of this tting
only - which screws
into the cylinder head.
Other ttings, as the
ones which attach to
the hydraulic pump,
assemble the same
but may not have the
indicator.)
Accessories and Service Kits
These items may be purchased separately from your local Titan
distributor.
Part # Description
103-627 Rock Catcher
550-110 S-5 G, T, and 1/4” x 50’ Hose Kit
550-111 S-5 G, T, and 3/8” x 50’ Hose Kit
580-050 LX-80 G, T, and 1/4” x 50’ Hose Kit
101-208 Grounding Clamp
101-212 Grounding Wire, 12 Gauge x 25’
314-480 Piston Lube
430-362 Coolo™ Hydraulic Fluid, 1 Quart
430-361 Coolo™ Hydraulic Fluid, 1 Gallon
144-050 Fluid Section Service Kit — Minor
930-050 Filter Service Kit
611-275-1 6” Gun Extension
611-276-1 12” Gun Extension
611-277-1 18” Gun Extension
611-278-1 24” Gun Extension
930-005 Filter element, 5 mesh, w/ball
930-007 Filter element, 100 mesh, w/ball
759-145 Headlight Kit
759-120 Floating Gun Kit
759-130 Paint Hopper
759-138 Second Gun Kit (with gun)
759-076 Second Gun Kit (without gun)
759-140 Lazer Pointer
759-150 Side Striper
424-826 Bead Dispenser, 1st Gun Kit, 4–6” line width
424-816 Bead Dispenser, 2nd Gun Kit, 4–6” line width
424-836 Bead Dispenser, 2nd Gun Kit w/Hopper,
4–6” line width
424-840 Bead Dispenser, 1st Gun Kit w/Hopper,
12” line width
424-841 Bead Dispenser, 2nd Gun Kit w/Hopper,
12” ine width
