20
HL66 (E/F) Web 213:276
Chapter 4: Setting up your TV
4 Press BbC c to select the antenna input and digital
channel whose signal you want to check.
Note: The physical digital channel number listed in the
Signal Meter screen may not correspond to a virtual TV
channel number. Contact your local broadcasters to
obtain the RF channel numbers for your local digital
stations.
To close the screen and return to the Terrestrial
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Viewing the system status
To view the system status:
1 Press Y and open the Setup menu.
2 Highlight Installation and press T. A new set of
Installation menu icons appears, as shown below right.
3 Open the System Status menu, highlight System
Information, and press T.
4 Press C c to scroll through the menu bar to select either
the Product Information or Software Version and
view the related information.
To close the screen and return to the Installation
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
1 Follow steps 1–3 under “Viewing the system status” at
left.
2 Press C c to scroll through the menu bar to select
Factory Defaults.
3 Enter your PIN code (or 0000 if no PIN code has been set).
4 Highlight Yes and press T. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the reset process.
To cancel the reset:
Highlight No and press T.
Signal Meter
Antenna 1
Physical Digital Channel 4
Virtual Digital Channel
Done
4/1
Signal Locked
0
0
Peak
CH RTNENTER
EXIT
Navigate
Select
Back Exit
CH RTNENTER
EXIT
Navigate
Select
Back Exit
Setup
Installation
Sleep Timer
PC Settings
PC Audio
Power-Saving
Auto
HDMI Audio
No
Power-On Mode
System Infomation
System Status
System Information
Done
Brand:
Model:
Toshiba
32HL66
Product Information
System Information
Done
2.2.26.0
Jan 24 2006 - 11:04:47
FW: 17
Software Version
System Information
Press YES to confirm. After the TV
turns off, unplug it and plug it back
in to complete the reset.
YesNo
2632HL66_EN.book Page 20 Tuesday, July 18, 2006 3:47 PM
