-61-
Choose the menu Advanced→Session Limit→Session List to load the following page.
Figure 4-31 Session List
In this table, you can view the session limit information of users configured with Session Limit. Click
the <Refresh> button to get the latest information.
4.5.4 Load Balance
On this part, you can configure how the traffic load is shared by the WAN ports to optimize the
resource utilization.
4.5.4.1 Configuration
Choose the menu Advanced→Load Balance→Configuration to load the following page.
Figure 4-32 Configuration
With the box before Enable Application Optimized Routing checked, the router will consider the
source IP address and destination IP address of the packets as a whole and record the WAN port they
pass through. And then the packets with the same source IP address and destination IP address or
destination port will be forwarded to the recorded WAN port. This feature is to ensure the
multi-connected applications to work properly.
Check the box before Enable Bandwidth Based Balance Routing and select the WAN port below,
Load Balance of the specified WAN port will be enabled automatically if no routing rules are set.
Then click the <Save> button to apply the settings.
Note:
The WAN ports not connecting to the Internet will not apply Intelligent Balance, please do not select
them.
4.5.4.2 Policy Routing
Policy Routing provides a more accurate way to control the routing based on the policy defined by the
network administrator.
