Tripp Lite B132-100-WP Manual

next previous

Installation

Note: Test to make sure the entire installation works properly before pulling cables

through ceilings/walls.

 FollowtheinstructionsthatcomewiththeB132-004LocalUnitbefore

connectingtheB132-100RemoteUnitorB132-100-WPWallplate.

For the B132-100:

UseCat5e/6cabletoconnectoneoftheOutputports

ontheB132-004LocalUnittotheInputportontheB132-100Remote

Unit.

For the B132-100-WP:

Usetheincluded110Punchdowntooltoconnect

eachofthecoloredwiresinsidetheCat5e/6cabletothecorresponding

areasofthe110Punchdownconnector,andthenconnecttheotherend

oftheCat5e/6cabletoanOutputportontheB132-004LocalUnit.

 ConnectamonitortotheOutputportoftheB132-100RemoteUnitor

B132-100-WPWallplateusingaTrippLiteP502-SeriesVGAcable.

 Firstturnonthemonitor,andthenturnonthecomputerconnectedto

theB132-004’sSourceport.Ifyourpictureistoodark,orisdisplaying

a“ghostingeffect,”usethescrewdriverincludedwiththeB132-100to

adjusttheEqualizationandGaincontrols.

B132-100

B132-004 Local Unit

B132-100WP

200901112 93-2866.indd 4 2/12/2009 2:51:35 PM