A SERVICE OF

logo

Assembly Instructions
Read Instructions Carefully Before
Assembly:
1. Connect the two ends of the Power
Cord (between the Base and the
Shaft) using the lock connectors.
2. Carefully tuck excess Power
Cord into the Shaft.
DO NOT CUT OR
SHORTEN THE POWER CORD.
3. Insert the Gooseneck and the
Shaft into the Base.
4. Check direction of the lamp and
the hole on the Base, then use
a Phillips Head Screwdriver (not
included) to tighten the screw into
the hole.
BE VERY
CAREFUL NOT TO PINCH ANY
PART OF THE CORD BETWEEN
ANY METAL PIECES.
MISE EN GARDE : PRENDRE
SOIN DE NE PAS PINCER LE
CORDON DANS DES PIÈCES
MÉTALLIQUES.
Fig. 1
7
CAUTION:
WARNING: