To remove rack, pull
forward until rack
stops, lift and pull.
Gasket
Using the oven light
The Oven Ltght will come on when the Oven Door IS opened.
1
0
@E
B
To replace the light bulb:
The oven light bulb has a glass cover which is held on by a wtre
0
holder.
This cover must be in place
when the oven is being used.
1. Turn off the electric power at the main power supply.
2. Pull out on the wire holder and move it to one side. This will let you
remove the glass cover and gasket.
To replace the oven
3. Replace the bulb with a 40-watt
appliance
bulb (designed to stand
light, remove glass
up to oven heat) available at most grocery, variety and hardware
cover and gasket.
stores
4. Replace the gasket and glass cover. Snap the wire holder in place.
Oven rack positions
Your oven has two racks. Always put the racks where you want
them to be
before you turn on the oven.
To remove a rack. take hold of it on the front edge and pull it out
until it stops. Then lift up the front edge and pull again. It will slide past the
stops. out of the guides and out of the oven.
To put it back, fit the back corners into the guides at each side of
the oven and slide it in.
keeping the front tilted up until the rack passes
the stops in the rack guides.
For:
Baking
Broiling
Roasting LARGE
cuts of meat
Roasting
SMALLER
cuts of meat
~___
Place Rack:
On the second or third rack guide from the top..
so food is in the center of the oven.
So food is about the distance from the broil
element suggested in the broiling ttmetable
under “Using the Oven Controls.”
On the bottom rack guides.
So food is in the center of the oven.
When baking, always leave at least 1% to 2 inches (4-5 cm) of
air space between the sides of a pan and other pans and the oven wall
for air circulation.
For best results. get additional information on placing pans. cookte
sheets and other utensils from the “Cooking Guide.”
