To remove rack, pull
forward until rack
stops, lift front and pull.
Replace with a 40-watt
APPLIANCE bulb.
Oven rack positions
Your oven has two racks. Always put the racks where you want
them to be
before you turn on the oven.
To remove a rack, take hold of it on the front edge and pull it out
until it stops. Then lift up the front edge and pull again. It will slide past the
stops. out of the guides and out of the oven.
To put it back, fit the back comers into the guides at each side of
the oven and slide it in,
keeping the front tilted upuntil the rack passes
the stops in the rack guides.
For:
Baking
Broiling
Roasting LARGE
cuts of meat
Roasting
SMALLER
cuts of meat
Place Rack:
On the second or third rack guide from the top..
so food is in the center of the oven.
So food is about the distance from the broil
element suggested in the broiling timetable
under “Using the Oven Controls.”
On the bottom rack guides.
So food is in the center of the oven.
When baking, always leave at least 1% to 2 inches (4-5 cm) of
air space between the sides of a pan and other pans and the oven wall
for air circulation.
For best results, get additional information on placing pans, cookie
sheets and other utensils from the “Cooking Guide.”
Using the oven light
To turn on the oven light, push the oven light switch. Push it again
to turn off the oven light.
To replace the oven light bulb:
1. Turn the electric power off at the main power supply.
2. Remove the light bulb from the socket.
3. Replace the bulb with a 40-watt
appliance
bulb (designed to stand
up to oven heat) available at most grocery. variety and hardware
stores.
The oven vent
There is an oven vent under the right rear surface element. When
the oven is on, heated air will escape through it. A vent is needed for air
circulation in the oven during baking. You can cook on this surface unit
while the oven is on. A warm pan of food will stay warm on this unit while
the oven is on. It may be warm enough to melt butter, too.
Do not try to save heat or energy by blocking the vent. Poor
baking can result. Plastic utensils may melt if they are over the vent
while the oven is on.
Setting the clock to the correct time of day
1. Push in the Minute Timer Knob and turn it clockwise to set the hands
to the correct time of day.
