Lighting standing pilots
To light range pilots:
1. Make sure all controls are turned off.
2. Remove the surface burner grates from the
cooktop. Lift the cooktop. (See “Lift-up
cooktop” on page 18.)
3. To light, hold a lit match over the pilot light
located between the front and back burners.
The pilot flame should be %to % in (.6-l cm)
high.
4. lf the pilot flame needs adjustment, turn the
pilot adjustment screw midway down the
length of the manifold pipe, behind the control
panel.
5. Lower the cooktop and replace the grates
before using the surface burners.
To light oven burner pilot:
1. Make sure the Oven Temperature Control is
turned off.
2. Remove the oven bottom (see “Removing the
oven bottom” on page 20). Then unscrew the
burner baffle located on the burner (see
Installation Instructions for more information
about the baffle).
3. Hold a lit match over the oven burner pilot
located at the rear of the burner.
4. After the oven burner pilot is burning
steadily, check burner lighting by turning the
Oven Temperature Control to a temperature
above 140°F (60°C). The burner will take
50-60 seconds to light.
5. Replace the burner baffle and oven bottom.
11
