NetWare Installation
Xerox WorkCentre 7232/7242 System Administration Guide 79
NetWare Installation
This section describes the installation procedures to use the machine in a NetWare
environment.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
Enable the SMB protocol.
Go to Properties->Connectivity->Port Settings.
1. At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2. In the [Properties] frame, select the plus symbol [+] to the left of the [Connectivity]
folder.
3. Select the plus symbol [+] to the left of the [Port Settings] folder.
4. On the SMB line, select the Enabled box. Select [Apply].
When using IPX:
Set the Netware protocol to [Enabled] using the touch screen or CentreWare
Internet Services.
When using TCP/IP:
Set the Netware protocol to [Enabled] using the touch screen or CentreWare
Internet Services. Set the IP address on the control panel or CentreWare Internet
Services.
For more information, refer to Network Communication Setup on page 79.
NetWare Setup
For more information, refer to NetWare Setup on page 81.
Workstation Setup
For more information, refer to Workstation Setup on page 81.
Test Print
For more information, refer to Test Print on page 81.
Network Communication Setup
Use this procedure to set up the network communication parameters of the machine.
