Introduction
Xerox LS 3270
- 5 -
Changing the Driver
To change from PCL to FSL driver or vice versa, first of all the
rotary switch has to be in position T at power on. The current
printer driver will be indicated on a printout. The actual selection of
printer driver is then made by turning the rotary switch to position A
(PCL) or B (FSL). The new position will also be indicated on a
second printout. When the correct position is obtained, turn the
rotary switch away from the A, B or T positions (any other position
will do). The new driver is now active.
Xerox LS 3270 Features
The Xerox LS 3270 protocol converter gives you the following fea-
tures:
• IBM 3287, 3268
1
and 4214 emulations
• Support of the SCS (LU1) and 3270 data stream (LU0 or
LU3) modes including FMH data streams as required by
the host system.
• All IBM RPQs
• Parallel output in PCL mode
• Up to 8 user strings of variable length can be transmit ted
to the printer from the Xerox LS 3270 - automatically at
power on and before and after Local Copy from the host
system.
• Automatic input sharing between Coax and Centronics
input ports.
• Coax FSL setup via share port
• Flash prom allowing downloading of new firmware via the
coax or the centronics port.
• Support of ida PSS
• Autoconfiguration (PCL only)
1
3268 = factory default
