Filter
Top Products
42
INSTALLATION AND UNINSTALLATION
NOTES OF INSTALLATION
1. Before installation, please make sure proper connections are conducted and the unit
operates normally. lmproper connection may result in damage to the unit.
2. Use only accessories designed and manufactured for this unit and other unauthorized
accessories may result in damage to the unit.
3. Before installation, please fasten all power cables.
4. DO NOT install the unit in the place where close to hot area to prevent damage to
electrical components such as the laser head.
5. lnstall the unit horizontally. lnstalling the unit more than 30 degree inclined may result in
worse performance.
6. To prevent electric spark, connect the positive pole first and then the negative pole.
7. DO NOT block the cooling fan exit to ensure sufficient heat dissipation of this unit, or it
may result in damage to this unit.
UNIT INSTALLATION
Method A
1. lnsert mounting bracket into dash board, choose appropriate mounting tab according
to the gap width, bending the mounting tab outwards with a screw driver to fix the
mounting bracket in place.
2. Use 2 pieces of M5 x 5 cone shaped screw to fix two assemble bars on both sides of
the unit (see picture 1).
(Picture 1)
3. Screw in 1 piece of M5 x 24 to the hole of the unit back and put on a rubber sheath over
the screw (see picture 2).