Filter
Top Products
Chapter 2 Installation 9
2.4 Jumper settings
You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To
close a jumper you connect the pins with the clip. To open a
jumper you remove the clip. Sometimes a jumper will have three
pins, labeled 1, 2 and 3. In this case you would connect either pins
1 and 2 or 2 and 3.
A pair of needle-nose pliers may be helpful when working with
jumpers. If you have any doubts about the best hardware configu-
ration for your application, contact your local distributor or sales
representatives before you make any changes.
1
2
Closed 2-3Open Closed