Filter
Top Products
1-5
Getting Started
Setting Up the Agilent 83434A
Step 2. Check the Fuse
1 Locate the line-input connector on the instrument’s rear panel.
2 Disconnect the line-power cable if it is connected.
3 Use a small flat-blade screwdriver to pry open the fuse holder door.
4 The fuse is housed in a small container. Insert the tip of a screwdriver on the
side of the container and gently pull outward to remove the container. A spare
fuse is stored below the line fuse.
WARNING For continued protection against fire hazard, replace line fuse only
with same type and ratings (5
×20 mm, 1.6 A, 250 V time-delay, low
breaking capacity fuse). The use of other fuses or materials is
prohibited.