Filter
Top Products
* This illustration is CDE-100EUB.
Accessory List
• Head unit ............................................................................1
• Power cable........................................................................1
• Mounting sleeve.................................................................1
• Carrying case.....................................................................1
• Bracket key.........................................................................2
• Rubber Cap ........................................................................1
• Bolt Stud ............................................................................1
• Owner’s Manual..........................................................1 set
Turning Power On and Off
Press SOURCE/ to turn on the unit.
• The first time power is turned on, the volume will start from level 18.
Press and hold SOURCE/ for at least 2 seconds to
turn off the unit.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press (Release) at the upper right side until the
front panel pops out.
3
Grasp the right side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it
may result in malfunction.
Attaching
1
Insert the left side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the right side of the front panel until it locks
firmly into the main unit.
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Adjusting Volume : 0 ~ 40
Setting Time
1
Press and hold VIEW for at least 2 seconds.
The hour indication will blink.
2
Press or to adjust the hours while the
time indication is blinking.
3
When the hour has been adjusted, press VIEW.
The Minute indication will blink.
4
Press or to adjust the minutes while the
time indication is blinking.
5
When the minute has been adjusted, press VIEW.
The setting time mode is completed.
• Hold down or to change numbers rapidly.
Getting Started
VIEW
SOURCE/
Rotary encoder
Controllable with Remote Control
This unit can be controlled with an optional Alpine
remote control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the
remote-control sensor.
Remote control sensor