Alpine CDE-130RR Car Stereo System User Manual


 
18-EN
Installation
The main unit must be mounted within 30 degrees of the horizontal
plane, back to front.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
3. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Secure the ground lead of the unit to a clean metal spot using a screw
(*3) already attached to the vehicle’s chassis.
Caution
Do not block the unit's heat sink, thus preventing air circulation. If
blocked, heat will accumulate inside the unit and may cause a fire.
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
1
Remove the mounting sleeve from the main unit
(see “Removal”).
Heat sink
Detachable Front
Panel
Less than 30°
Bracket
Bolt Stud
(Included)
This unit
Snapping Point
Mounting Sleeve
(Included)
Rubber Cap
(Included)
Dashboard
2
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (
*1) already
attached to the vehicle’s chassis.
For the screw marked “*2”, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier to
the corresponding output lead coming from the left
rear of the CDE-130R/CDE-130RM/CDE-130RR.
Connect all other leads of the CDE-130R/CDE-
130RM/CDE-130RR according to details described in
the CONNECTlONS section.
3
Slide the CDE-130R/CDE-130RM/CDE-130RR into the
dashboard until it clicks. This ensures that the unit is
properly locked and will not accidentally come out
from the dashboard. Install the detachable front panel.
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
(Included)
Ground Lead
Screw
This unit
*2
*
1
Bracket Keys
(Included)
This unit
Front Frame
(Included)
This unit
Screws (M5 × 8)
Mounting Bracket
Ground Lead
*3