Filter
Top Products
20-EN
1 Antenna Receptacle
2 ISO Connector
3 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse
box or another unused power source which provides (+) 12V
only when the ignition is turned on or in the accessory
position.
4 Power Antenna Lead (Blue/White)
Connect this lead to the +B terminal of your power antenna,
if applicable.
Note
• This lead should be used only for controlling the vehicle’s
power antenna. Do not use this lead to turn on an amplifier or a
signal processor, etc.
5 Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
6 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s
battery.
7 ISO Power Supply Connector
8 Rear Left (+) Speaker Output Lead (Green)
9 Rear Left (−) Speaker Output Lead (Green/Black)
0 Front Left (+) Speaker Output Lead (White)
! Front Left (−) Speaker Output Lead (White/Black)
@ Rear Right (−) Speaker Output Lead (Grey)
# Rear Right (+) Speaker Output Lead (Grey/Black)
$ Front Right (−) Speaker Output Lead (Violet)
% Front Right (+) Speaker Output Lead (Violet/Black)
^ Fuse Holder (15A)
& Front Output RCA Connectors
RED is right and WHITE is left.
* RCA Extension Cable (sold separately)
( Front AUX Input Terminal
This terminal allows for input of audio from an external
device (such as a portable player), using a commercially-
available converter cable.
) USB Connection Terminal
Connect USB memory (sold separately)
- Steering Remote Control Interface Connector
To steering remote control interface box.
You can operate this unit from the vehicle’s control unit when
an Alpine Steering Remote Control Interface Box (optional)
is connected. For details, contact your Alpine dealer.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.