Alpine CDE-9880R Car Stereo System User Manual


 
25-EN
No CD is inserted.
- Insert a CD.
Although a disc is inserted, “NO DISC” is displayed and the unit
does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
Mechanism error.
1) Press the button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
button again.
If the error indication still does not turn off after pressing the
button for a few times, consult your Alpine dealer.
When “ERROR” is displayed:
If the disc cannot be ejected by pressing , press the RESET switch
(refer to page 7) and press again.
If the disc still cannot be ejected, consult your Alpine dealer.
A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
USB memory is a malfunction or it is shorted.
- Connect another USB memory.
A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
Text information that is not recognizable by the unit has been
input.
- Use a USB memory device with input text information that is
supported by the unit.
The iPod is not connected.
- Make sure the iPod is correctly connected (refer to
“Connections”).
Make sure the cable is not bent excessively.
There are no songs in the iPod.
- Download songs to the iPod and connect to this unit.
Communication error
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPod and this
unit, using the iPod cable.
Caused by the iPod Software Version not being compatible with
this unit.
- Update the iPod Software Version to be compatible with this
unit.
Indication for CD Player
Indication for USB memory
DEVICE ERROR
Indication for iPod Mode
NO USB UNIT
NO SUPPORT