Alpine DVI-9990 Car Stereo System User Manual


 
9-EN
Video output connector
Outputs a video signal.
Connects to the video input of the TV monitor you are linking with.
There is a copy protect signal included in the video output signal, so that recording
with a VCR (Video Cassette Recorder) etc., is not possible.
Also, depending on the monitor, the picture may not be displayed correctly.
IONBUS terminal
Connects with IONBUS compatible products.
S video output terminal
Outputs a video signal.
Connects with ALPINE products with a S video input terminal.
DVD Audio Link terminal
Connects with the DVD Audio Link terminal of the PXI-H990 Multimedia Manager or
DAI-C990 DAC unit.
(Connect when using a DVD audio disc. Remove the terminal cover and plug in the
DVD Audio Link cable).
Connections
Basic Connection
NOTES
Do not install the power supply unit where it will be exposed to moisture such as under the floor mat or near the air
conditioner. This may cause a malfunction.
Do not bundle the power supply unit cable with the audio cables. Noise may be induced into your system.
The power supply unit temperature can become hot. This is not a malfunction.
Antenna Receptacle
Power Antenna Lead
Connect this lead to the +B terminal of your power antenna, if applicable.
Illumination Lead
This lead may be connected to the vehicles instrument cluster illumination lead.
This will allow the backlighting of the DVI-9990 to dim whenever the vehicles
lights are turned on.
Ground Lead
Connect this lead to a good chassis ground on the vehicle. Make sure the
connection is made to bare metal and is securely fastened using the sheet metal
screw provided.
Switched Power Lead (Ignition)
Connect this lead to an open terminal on the vehicles fuse box or another unused
power source which provides (+)12V only when the ignition is turned on or in the
accessory position.
Battery Lead
Connect this lead to the positive (+) post of the vehicles battery.
Blue
Orange
Black
Red
Yellow
Fuse
(7.5A)
Cable Color
Cable Specifications
Yellow
Power supply unit