Filter
Top Products
7
Check accessory parts.
Remote Control
Holder
Remote
Control
Solderless
connector
Parking brake
aux. cord
Cable clampAntenna
mounting plate
GPS antenna
Power cable
1 Bracket 5
Flanged self-tapping
screw (M5 × 15)
4 Hex bolt (M6 × 50)3 Screw with double
washer (M5 × 8)
2 Floor base
One each left and right
6 Spring
washer (M6)
7 Flanged Hex
Nut (M6)
8 Wing Nut (M6) 9 Velcro
Fastener
" Self-tapping
Screw (M3 × 12)
! Velcro Tape
× 3
× 2
× 2
× 2
× 4
× 4 × 4
× 4× 4
× 4
× 2
× 4
Prepare tools and mounting information.
Screwdriver Pencil and eraserSpannerPliersElectrical tape
Park the vehicle in a safe and level location.
Apply the brake and remove the ignition key.
Mount the antenna on the roof.
Clean dust and oil at the mounting location and mount the antenna.
Notes:
• The magnet of the antenna is very strong. Proceed cautiously to prevent any
damage to the vehicle’s body. Keep the magnet away from articles susceptible
to magnetic fields such as credit cards, watches, etc.
• Do not paint the antenna. Reception sensitivity may be decreased.
Mounting the antenna inside the vehicle.
1. Clean the mounting location.
2. Put on the antenna mounting plate.
3. Mount the antenna.
Notes:
• Mount the antenna on a flat plane of the dash board or rear tray.
• Some thermal reflection type or thermal absorption type glass may interrupt
high frequency waves. If reception is poor with the antenna installed inside the
car, try to mount the antenna outside the car.
Antenna
Antenna
1
2
3
4
5
13P RGB extension cable (6 m)
Battery (AAA)
(2.5 m)
(4.5 m)
(5 m)
1. Preparation