Filter
Top Products
4
Step 4
Take the end of the cable with the right angle connector and plug
it into the back of the Alpine head unit as shown in Fig 3. The
other end of the cable coming from the white rectangle connector
is a pass through cable that can be used to connect other Alpine
products to your Alpine head unit, i.e. CD changer.
Note: The location of the connections on the Alpine head unit may
vary depending on the Alpine model.
Step 5
Start your car and turn on your Alpine head unit to confirm that
the XM Direct system is properly connected. When you tune to
XM channel 1, you should see “XM Preview” on your Alpine head
unit LCD, and hear that channel through your car speakers.
If not, check to make sure all connections are correct or refer to
the trouble shooting section of this installation guide.
Step 6
Mount and secur
e the XMDALP100 in a suitable location that
will not interfere with the radio and will not vibrate or rattle
after installation.
Smart Digital Adapter
Fig 3