Filter
Top Products
1. Power/Stand-By mode:
The Power / Stand-By button has two possible operation modes.
a. Manual mode - Turned on manually by the user by pressing the Power button.
b. Stand-By mode -Turned on by a stand-by trigger wire generally connected to
the vehicles 12V reverse back up lights or turn signals.
Manual Mode wiring - For manual mode operation, the AOM703 should be wired
as follows:
ACC (12V+) Red wire should be connected to the vehicles accessory feed.
GND - Black ground wire should be connected to chassis ground.
Standby Mode wiring - For standby mode operation, the AOM703 should be
wired as follows:
ACC (12V+) Red wire should be connected to the vehicles accessory feed.
GND - ground wire should be connected to chassis ground.
Standby Camera Trigger 1, Blue wire, should be connected to the reverse feed of
the vehicles back up lighting system. When triggered, the Reverse Camera
Image will be displayed on AV1.
Standby Camera Trigger 2, Brown wire, should be connected to the trigger
feed of the vehicles Left turn signal. When triggered, the Left Camera image
will be displayed on AV2.
Standby Camera Trigger 3, Green wire, should be connected to the
trigger feed of the Vehicles Right turn signal. When triggered, the Right
Camera image will be displayed on AV3.
* Note : The unit will not be turn ON when the hazard light are activated.
CONTROLS AND OPERATION
–
+
1 2 3 4 5
S
S
4