Filter
Top Products
Installation Procedure
1. To prevent a short circuit, remove the key from the ignition and disconnect the (-) battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the speaker wires of the wiring harness
4. Connect the wiring harness connector in the following order : Ground, Battery, Ignition.
5. Connect the wiring harness connector to the unit
6. Install the unit in your car
7. Reconnect the (-) battery
8. Press the reset button
Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and
secure the unit with the accessory screws.
NOTE: This installation method is a reference example. Make sure that the
unit is installed securely in place. If the unit is unstable, it may malfunction
(for example, the sound may skip)
Installation
Installation
35