Filter
Top Products
controls and functions
5
8
7
6
5
4
3 21
PWR
MIN
MAX
SUB
LEVEL
R
DIGITAL BASS RECONSTRUCTION PROCESSOR
ABD40J
REMOTE
+12V GROUND
DASH REMOTE
L R
OUTPUT
RL
INPUT
BALANCED
-80Hz
-35Hz
-50Hz
MAXMIN
SWEEP
MIN MAX
WIDE
CONTROL
BASSMAX
POWER
1. Balanced Input: Low Input is used to balance the input circuit to help minimize noise.
They are designed to handle high voltage signals up to 15 volts.
2. Outputs: RCA connectors must be connected to the next component after the bass
processor, like a crossover, equalizer or amplier. Remember the bass processor
must be connected before a crossover.
3. Remote Control.
4. Power connector
5. Controls: These two knobs control the functions of the Bass processor features.
SWEEP knob allows to choose the desired center frequency.
WIDE knob adjusts the frequency range of low impact processor.
6. The PFM subsonic lter switch: Bass Processor uses a PFM subsonic lter switch that
will helps the speaker control and manage the power amplier. This switch comes with
three selections 35Hz/50Hz/80Hz frequency. In most programming systems is 35Hz, if
you want to further protect your speaker system, try a higher frequency. Often, higher
frequency sounds louder and clearer.
7. Maximize Bass Indicator: All three LED indicators ash when the maximization of the
lower circuit is activated.
8. The L.E.D. indicates when the unit is on.