Filter
Top Products
Warning And Disclaimer
8
TROUBLESHOOTING GUIDE
If the unit does not light up or the LED indicator light does nothing check the following:
1) Check to make sure the +B and GND are not reversed.
2) Check that all cables are connected properly and have adequate power (11-16 volts).
3) Check that the fuse is intact.
If you experience high or low volume audible distortion output:
4) Check that the input and output levels are set correctly.
5) Check the crossover, make sure it is correct. For systems of high “Q”, set 1 octave or
down.
If you experience noise of the machine:
6) Verify that the GND connection is secure, the conductor (cable) is not too thin and
unnecessarily long.
7) Check that the cable +B is not too thin and unnecessarily long.
8) Change the source for output.
Investigate the layout of your automobile thoroughly before drilling or cutting any holes. Take care
when you work near gas tanks, gas lines, hydraulic lines, and electrical wiring. Do not use the power ampli-
er unmounted. Attach the system securely to the automobile to prevent damage, particularly in the event of
an accident. Do not mount the system so that the wire connections are unprotected or are subject to pinching
or damage from nearby objects.
The +12V DC power wire must be fused at the battery positive terminal connection. Before making or break-
ing power connections at the system power terminals, disconnect the +12V wire at the battery end. Con-
rm your radio/head unit and/or other equipment is turned off while connecting the input jacks and speaker
terminals. If you need to replace the power fuse, replace it only with a fuse identical to that supplied with the
system. Using a fuse of a different type or rating may result in damage to this system which is not covered by
the warranty.
Disclaimer
Specications are subject to change without notice.
For the most updated Specications call Audiobahn,
your local Authorized Audiobahn Dealer,
or check the Audiobahn web site.
www.audiobahn.com