Filter
Top Products
10
II. PREPARATION OF CONSOLE FOR INSTALLATION
1. Position the O.E.M. console in the front recess
area of the new console (item 4 pg 2 ). Carefully fit
the two together, aligning the rear compartment
hinge arms through the slots in the recess pocket
area. See figure 14.
2. Secure the O.E.M. compartment assembly into the
console recess using (10) ten # 6 X 1/2" screws
( item 9 pg 2 ). Start all screws before tightening
beginning with the front center, rear center, then
alternately on each side. See figure 15. Caution:
Do not overtighten screws.
FIGURE 14
FIGURE 15