Filter
Top Products
3
1. Remove and discard front mounting screw from
overhead console and pull downward to
release clips at rear of console. See Figure 1.
2. Disconnect wiring harness from console. See Fig. 2.
Lay console in a safe place. Remove and retain (2) two
O.E.M. screws from plastic bracket. Transfer Velcro
tape from console to identical location on new console
(item 4 pg 2).
3. Carefully trim headliner and return air grille as
shown. Make sure that the 7” cut is centered left
to right in vehicle. See Figure 3. Caution:
Before cutting headliner material, check for
wiring or other componentry above
headliner. Cut only where indicated.
FIGURE 3
FIGURE 1
FIGURE 2