Filter
Top Products
4
4. Install mounting bracket (item 6 pg 2) and secure using
(2) two # 10 x 3/4" screws (item 1 pg 2) in bottom
flange that aligns with dimples in roof brace. Secure
top flanges using (2) two # 8 x 3/4" screws (item 3 pg
2). See Figure 4.
III. INSTALLATION OF CONSOLE
NOTE: Additional assistance in mounting the overhead console in vehicle is advised
to prevent damage to console or components.
5. Install and route all accessory wiring, video and audio cables, and any other added component
requirements to their respective places in the
vehicle. Refer to component installation
instructions for wiring diagrams. The suggested
routing of the video system cable is as follows:
Above the headliner from video system to B-pillar.
Down the B-pillar to the floor. Route the power
lead to an accessory controlled source. Connect
the ground lead to the vehicle chassis. Route the
remaining wiring (RCA plugs, Remote Sensor
extension, etc.) to the VCP location. See Figure 5.
Connect per instructions included with video
system. If video system is to be used as a
television, install an appropriate antenna per
instructions included with antenna.
FIGURE 4
FIGURE 5