Filter
Top Products
4
8. Install and route all video and audio cables, and any
other added component requirements to their
respective places in the vehicle. Refer to component
installation instructions for wiring diagrams. The
suggested routing of the video system cable is as
follows: Above the headliner from video system
rearward to the C-pillar. Down the C-pillar to the
floor. Route the power lead to a fused accessory
controlled source. Connect the ground lead to the
vehicle chassis. Route the remaining wiring (RCA
plugs, Remote Sensor extension, etc.) to the VCP
location. See Figure 4. Connect per instructions
included with the video system. If video system if to
be used as a television, install an appropriate antenna
per instructions included with the antenna.
9. Install console mounting bracket (item 6 pg 2)
over O.E. bracket on roof brace. Align bend in
bracket with edge of O.E. brace. Secure bracket
using (4) four # 8 x 9/16" screws (item 1 pg 2).
See Figure 5.
II. INSTALLATION OF CONSOLE
IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED.
10. Raise console (item 7 pg 2) into approximate
position against headliner. Loosely install using (2)
two 6-32 X 3/4" screws (item 2 pg 2) through the
smaller holes in bracket on console into threaded
clips on mounting bracket. See Fig. 6.
11. Using a scribe or similar tool, align hole in rear of
console with slot in mounting bracket. Loosely
secure rear of console using (1) # 8 X 1 1/2" screw
(item 4 pg 2). Make sure console is straight then
tighten (2) two 6-32 screws previously installed.
See Figure 6.
FIGURE 6
FIGURE 4
FIGURE 5