Filter
Top Products
5
12. Release video screen from locked position. Lower
video screen to viewing position for access to
mounting locations in top of video system
housing.
13. Raise video system into approximate position and
connect all wiring to components. Connect wiring
and cabling to video system per instructions
included with video system.
14. Check function of all components and lights. See
operating instructions for video system operations
check. For further assistance, refer to the video
system manual for the technical support phone
number listed for your area.
15. Insert video system into opening in console. Note: Make sure wires do not get pinched between video
system and console. Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32 x
3/4" screws (item 2 pg 2) and (4) four 3.5 mm washers (item 3 pg 2). See Figure 7.
Caution: Do not overtighten screws.
16. Tighten screw previously installed to secure rear of
console to headliner. Caution: Do not overtighten
screws or damage to vehicle roof may occur.
17. Raise video screen into locked position.
18. Install speaker grille (item 8 pg 2). Align clips in grille
with holes in console and press firmly.
See Figure 8.
19. If speaker upgrade kit was not installed, install cover
plate (item 9 pg 2) at front of console and secure
using (2) two # 6 X 1/2" screws (item 5 pg 2 ).
20. Install cover plate decal (item 10 pg ).
FIGURE 7
FIGURE 8