Filter
Top Products
1111
1111
11
OPEROPER
OPEROPER
OPER
AA
AA
A
TT
TT
T
ING INSTRUCING INSTRUC
ING INSTRUCING INSTRUC
ING INSTRUC
TT
TT
T
IONSIONS
IONSIONS
IONS
dldl
dldl
dl TIME/FREQUENCY DISPLAY SELECTOR (T/F)
Press this button to call the time display on the
incorporated quartz clock. Press the button again
to return to radio frequency or disc display, or it
will return automatically after 5 seconds.
dmdm
dmdm
dm THEFT-DETERRENT LED
A light-emitting diode (LED) with lens is mounted
on the front of the chassis behind the panel mount-
ing plate; the LED will flash at 1-second intervals
when the panel folds down, and will flash at 2-
second intervals when the panel is removed from
the radio. The flashing light serves as both a
visual reminder that the panel has been released,
or as a warning to a would-be thief that the unit
has been disabled by removal of the front panel.
dndn
dndn
dn RESET BUTTON
A RESET button is accessible on the rear of the front
panel when it is in the fold-down position. The reset
circuitry is provided to protect the microproces-
sor circuitry and should only be activated un-
der the following circumstances.
1. Upon initial installation after all wiring is
completed.
2. If there is a malfunction of any of the
switches on the unit or of the CD player,
pressing the RESET button may clear the
system and return the unit to normal op-
eration.
CAUTION: Pressing the RESET button will cause
all discs to be ejected. When the RESET button
is pressed be certain that the front panel is in the
down position.
dodo
dodo
do FRONT PANEL RELEASE (REL) BUTTON
This button is used to release the mecha-
nism that holds the front panel to the chas-
sis. To detach the front panel, press the but-
ton; the panel will fold down to the horizontal
position. At the center of the panel, press the
release clip to disengage the panel from the
mounting plate, and pull the panel straight
out until it clears the mounting plate guides.
To re-attach the panel, position the panel so
both sides engage the mounting plate guides;
then slide the panel home until the mecha-
nism locks it into place in the mounting plate.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-up
when attaching it to the chassis as it
cannot be attached when up-side down.
2. Do not press very hard on the front panel
when attaching it to the chassis. No
more than light to moderate pressure
should be needed.
3.When attaching the front panel, make
sure the right side is correctly engaged
before pressing the left side to lock it into
position.
4.When taking the front panel with you,
please use the supplied carrying case
to protect the panel from dirt and damage.
FRONT PANEL
MOUNTING PLATE
GUIDE (2 PLACES)
PANEL MOUNTING
PLATE
DISC SLOT
CD EJECT
( ) BUTTON
RESET BUTTON
(32)
DISC SELECT
(DISC SEL)
BUTTON
PANEL RELEASE
CLIP (PRESS TO
REMOVE PANEL
FROM MOUNTING
PLATE)
DISC SELECT
DISPLAY
THEFT DETERRENT
LED