Filter
Top Products
1515
1515
15
Indicates the disc is not loading or ejecting properly. Try re-loading or pressing the Eject
button again. Check the condition of the disc in use or try another disc.
Indicates an interface error between the disc mechanism and radio circuitry. Press the
Re-Setbutton dm andtryagain.
Indicates an error in the laser reading the disc. Eject the disc, make sure it is clean,
undamaged, and loaded correctly (label side up). Re-load the disc and check for proper
operation or try another disc.
Indicates a system error. Press the Re-Set button dm and try again.
Indicates that a computer CD-ROM hasbeen loaded into the unit. Eject the disc and load
an audio CD.
If the suggested measures do not solve the problem, contact an approved warranty station near you for
further assistance.
ER 1:
ER 2:
ER 3:
RST:
ROM:
ERROR CODESERROR CODES
ERROR CODESERROR CODES
ERROR CODES
If a problem should develop while operating the CD player, the following error codes may be displayed
on the display panel:
SETTING THE CLOCKSETTING THE CLOCK
SETTING THE CLOCKSETTING THE CLOCK
SETTING THE CLOCK
1. Turn the radio on so that the radio frequency or clock time is shown on the display panel.
2. Press and hold the Time/Frequency Display Selector button cu approximately 2 seconds until the
time display begins flashing.
3. While continuing to hold the Time/Frequency Display Selector button, press the Down Seek Tuning
button ( ) bp to adjust the hours and the “PM” indicator and the Up Seek Tuning button ( ) bo
to adjust the minutes to the correct time.
4. When the correct time is shown on the display panel, release the Time/Frequency Selector button.
FREQUENCY STEP SWITCHFREQUENCY STEP SWITCH
FREQUENCY STEP SWITCHFREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel
spacing on AM/200 KHz. spacing on FM). Use in other areas in the world may require different channel
spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/50 KHz. FM channel
spacing. Slide the switch to the appropriate position using a small screwdriver blade. The Re-Set button
dm on the front of the chassis must then be pressed to activate the change of channel spacing.