Filter
Top Products
-7-
88
88
8 FM MONO/STEREO (MO.ST) BUTTON
During FM radio reception, this button is used to
select mono or stereo reception. Under normal
reception conditions, the unit should be left in the
stereo mode, as indicated by the FM Stereo
indicator. If the stereo signal is too noisy for comfort-
able listening, press the MO.ST button to switch to
mono reception.
99
99
9 LOCAL/DISTANT (LO.DX) BUTTON
This button allows maximum reception in both weak
and strong FM signal areas. For normal reception
conditions, and when receiving a wide range of
signals, including weak or distant stations, this
function should be set to the Distant (DX) position,
which will allow maximum signal reception. When in
an extremely strong (local) signal area, select the
Local (LO) setting. This will eliminate weak signals
and suppress overly strong signals. When moving
out of the strong signal area, switch to the Distant
setting.
NOTE: The Local/Distant button only affects FM
signals, and will have no effect on AM
signals.
4 4
4 4
4 TONE CONTROL
Rotate this control knob to adjust the sound output
for the desired bass or treble tonal range. When the
control is positioned at the mid-range detent posi-
tion, the bass and treble response should be very
nearly equal.
To increase bass response, rotate the control CCW;
to increase treble response, rotate the control CW.
55
55
5 AM-FM BAND SELECTOR
Press this button to change the radio band from AM
to FM and vice-versa.
66
66
6 MANUAL TUNING CONTROL
Rotate this knob to the left or right to select the
desired radio station. When tuning in a station,
always adjust the control so that you are receiving
the full signal and are on the center of the broadcast
frequency. If the radio is off frequency, you could
experience noise and reception problems. The pointer
will move along the dial to indicate the frequency to
which you are tuned.
77
77
7 FM STEREO INDICATOR
This LED indicator within the AM/FM dial will illumi-
nate red during reception of FM stereo broadcasts;
if the stereo station is mistuned (not in the center of
the frequency) this indicator may light intermittently
or not at all.