Filter
Top Products
blbl
blbl
bl AM ANTENNA TRIMMER
It is very important to adjust the Antenna Trimmer for
optimum AM reception. The antenna trimmer is
located on left rear corner of the chassis. Adjust this
control after wiring connections are complete and
before the radio is inserted into the dashboard
opening. Proceed as follows:
1.Tune in a weak station around 1400 kHz on the
AM band.
2.Using a small screwdriver, slowly adjust the
trimmer for maximum output from the radio.
NOTE: The Antenna Trimmer only affects AM
reception, and will have no effect on FM
reception. The Trimmer only needs to be
adjusted when the radio is first installed
and at any time a change is made to the
vehicle antenna (replacing the mast, etc.).
bmbm
bmbm
bm CASSETTE DOOR
Hold the cassette with the exposed tape edge to the
right and insert it into the cassette door. Press in
fully until the cassette is engaged and begins
playing.
NOTE: Observe the cassette operation cautions
in the Care and Maintenance section of
this manual.
-8-
bnbn
bnbn
bn FAST-FORWARD/EJECT (FF/EJ) BUTTON
This button performs two functions. To eject a
cassette, simply press the button fully then release.
The cassette will eject and radio operation will
resume.
To fast-forward the tape, press the button half-way in
to the locked position. To stop fast-forward and
resume normal tape playback, press the button
slightly and release. Do not press fully in or the
cassette will be ejected.
NOTE: Never leave a cassette engaged in the
player when not in use. Doing so can
cause damage to the cassette and/or
mechanism of the unit. Always press the
eject button and remove the cassette
when leaving the vehicle.
bobo
bobo
bo AM/FM DIAL DISPLAY
This dual tuning dial represents the AM (bottom)
frequency band from 530-1710 kHz, while the top
dial represents the FM frequency band from
87.7-107.9 MHz. The AM station frequencies on
the dial must be multiplied by a factor of 10 (x10)
as shown. The dial pointer traverses the dial using
the TUNING control knob in conjunction with the
AM/FM BAND select button.