Filter
Top Products
CHRYSLER-DODGE-PLYMOUTHINSTALLATION
ALL U.S. MADE CARS, TRUCKS, AND VANS BUILT SINCE 1974
ImRortant- This radio cannot be installed in any U.S. made Chrysler, Dodge, or Plymouth vehicle without an
installation kit. Refer to the Kit Listing on Page 2 for the required kit. Complete kit installation is explained in the
instructions included with the kit.
I~
A. Remove the existing dashboard trimpanel surrounding the radio opening. This panel is usually secured by
screws and/or snap-in clips.
B. Remove the two large screws used to secure radio to the sub-dashboard.
c. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring harness(es) and antenna cable and remove the radio.
2. Install the lew Radio:
A. Follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with
the kit.
B. Place the radio near the dashboard so the wires can be led through the opening and following the instructions
of Step 2 on Page 3, carefully wire the radio making certain all connections are secure and insulated and
confirm proper operation.
C. Install the radio/mounting plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above orbelow
the radio using the screw and nut provided. Bend the strap to position it as necessary.
CAUTION: The rear of the radio mY§l be supported with the strap to prevent damage to the dashboard from the
weight of the radio or improper operation of the radio due to vibration.
E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.
I
b.