Filter
Top Products
- 9 -
1) Choose an appropriate mounting location
underneath a cabinet or shelf. Close proximity to
an electrical outlet and a TV antenna or cable
connection will facilitate a neat, easy installation.
Do not mount the VE1040 above a range or
oven. Be sure that the location chosen will
provide adequate access to the electrical
connection on the rear of the unit before
continuing.
2) If the location chosen has bottom edge molding it
may be necessary to use the mounting spacers
provided to effectively lower the VE1040 below
or even with the molding. Measure the distance
between the bottom and the bottom of the
cabinet. For large molding choose a combination
of spacers which will allow the VE1040 to be
secured to the bottom of the cabinet.
3) Measure the thickness of the bottom of the
cabinet or shelf and the spacers chosen. Select
the shortest screw length which will secure the
VE1040 to the bottom of the cabinet.
4) Cut out the template supplied and tape it in place
onto the cabinet surface to be drilled. Center
Punch the four holes indicated on the template
and remove the template.
5 ) Carefully drill four 1/8” holes at the locations
marked above. Place the screws selected through
the VE1040 and then through the spacers(if
required from the bottom-up).
6) Position the VE1040 and screw it in place using
the selected screws. Do not overtighten.
7) Connect your TV antenna or cable system to the
antenna connector on the rear of the VE1040.
8) Plug the AC wire into connector on the rear of
the VE1040 and then into the wall.
9) If using the speaker phone feature, plug the
VE1040 into a phone jack.
10) Attch the FM Dipole Antenna to the FM Antenna
screws.
11) Route the wires safely away from heat and
moisture sources and secure them in place using
the self adhesive wire mounting clip provided.
Under Cabinet Installation
FRONT VIEW SIDE VIEW