Filter
Top Products
128-6323
9 of 20
9) Using your fingers, tear the foam
out of the headrest leaving a re-
cess where the shell will be in-
serted.
NOTE: At this point you will need to
install the harness up through the area
into the recess. It may be helpful to
follow one of the posts and tie wrap it
to the post for restraint.
6) Using the utility knife, cut the
headrest material along the “X”
lines. Do not cut the material
along the other lines at this time.
7) This will leave you with an “X” cut
as shown.
8) Pull the flaps up and cut the foam
beneath the material to the proper
depth. Cut all four sides of the
foam.
8