Filter
Top Products
6
Installation Guide
TRIM RING INSTALLATION:
If the video monitor is to be installed with the trim ring, you may want to remove the rubber gasket first.
(See the drawing below).
1) Lay the MMD85A down on a soft surface to avoid
scratching the unit. Grasp the rubber gasket
above the DVD slot and pull it off in a circular
motion. (Refer figure 1)
Rubber Gasket
Fi
g
ure 1
2) The trim ring is attached to the video monitor
using the perimeter screw bosses. It is important
that the screws used in this installation are not
overtightened, and that the video monitor and trim
ring are mounted in such a way that the assem-
bly does not distort (or bend) when the mounting
screws are tightened. The trim ring MUST be
screwed to the unit. (Refer figure 2)
Fi
g
ure 2
Trim Ring
Fi
g
ure 3
3) The MMD85A is now ready to be mounted in the
vehicle. (Refer figure 3)