Filter
Top Products
8
Installation Guide
1) Make the connections to the vehicle for the 2 pin wiring harness.
2) Connect the 2 pin harness to the mating connector on the Video Monitor.
3) Connect power harness to vehicle's electrical system by tapping into an accessory hot line and a
good ground.
4) Verify all functions of the System before final mounting of the finished assembly.
Note: A VCP or other A/V Component can be connected to the video monitor system using
the LINE IN RCA jacks.
A/V Source Definitions :
1 = Built-in DVD
2 = AV1 input ( VCD, Game or future DVD, etc )
3 = AUX input ( VCD, Game or future DVD, etc )
* NOTE: If the relay box P/N SIRSWB is installed, it recommended that the antenna for the
wireless FM Modulator be unplugged. See Figure A for antenna location.
** NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to
exceed FCC limits for wireless transmission. When installing the unit position the antenna
for best reception.
MMD85A
CHOKE
Power Harness
Item # 3
Line In-R (Red)
Line In-L (White)
Line In-V (Yellow)
Red/Black (Lamp On)
* ANTENNA FOR WIRELESS FM MODULATOR
** See Antenna Note Below
Violet/Brown (Lamp Auto)
Black/Red (Lamp Common)
Dome Li
g
ht
Power Source
* OPTIONAL RELAY BOX
SIRSWB