Filter
Top Products
128-6887
8 of 12
-8-
Engage right side first
ATTACHING THE FRONT PANEL
DETACHING THE FRONT PANEL
Release button
SETSET
SETSET
SET
TT
TT
T
ING THE CLOCKING THE CLOCK
ING THE CLOCKING THE CLOCK
ING THE CLOCK
1. Switch the vehicle ignition “on” and the radio “on” (radio fre-
quency or disc track number will be shown on the display
panel).
2. Momentarily press the Time/Frequency (T/F) button to display
the time of day. The press and hold the T/F button until the time
display flashes.
3. While the display is flashing, press the Up Tuning button
( ) to adjust the hours and the AM or PM indication, and
the Down Tuning button ( ) to adjust the minutes to the
correct time.
4. When the correct time is shown on the display panel, press
and release the TF button (or wait 5 seconds) for the display
to return to the normal indication.
CD PLCD PL
CD PLCD PL
CD PL
AA
AA
A
YER ERRYER ERR
YER ERRYER ERR
YER ERR
OR CODESOR CODES
OR CODESOR CODES
OR CODES
If a problem should develop while operating the CD player, the
following error codes may be displayed on the display panel:
ER-2: Indicates the disc is not loading properly. Try reloading or
pressing the Eject button. Check the condition of the disc
in use or try another disc.
ER-3: Indicates the disc is not ejecting properly. Try pressing
the Eject button again. Check the condition of the disc
in use or try another disc.
ER-4: Indicates an error in the laser reading the disc. Eject the
disc, make sure it is clean, undamaged, and loaded cor-
rectly (label side up). Reload the disc and check for proper
operation or try another disc.
ER-5: Indicates excessive temperature conditions. CD play will
resume when the temperature returns to the normal
range.
ER-6: Indicates a mechanism error. Eject the disc and try re-
loading. Also try activating the RESET button
cucu
cucu
cu and try
again.
ER-7: Indicates an error in the laser reading the disc. Eject the
disc, make sure it is clean, undamaged, and loaded
correctly (label side up. Re-load the disc and check for
proper operation or try another disc.
ER-8: Indicates an error in the laser reading the disc. Eject the
disc, make sure it is clean, undamaged, and loaded
correctly (label side up). Re-load the disc and check for
proper operation or try another disc.
If the suggested measures do not solve the problem, contact an
approved warranty station near you for further assistance.