Filter
Top Products
128-6864
15 of 16
-15-
Should this occur, the player will not operate properly until the
moisture has evaporated.
l The unit is designed with a vibration dampening CD mechanism to
minimize interruption of disc play due to normal vibration in a
moving vehicle. When driving on very rough roads,
however,occasional sound skips may occur. This will not scratch
or damage the disc and normal play will resume when the rough
conditions cease.
HANDLING COMPACT DISCS
Dirt, dust, scratches, and warpage can cause skips in the playback
and deterioration of sound quality. Please follow these guidelines
to take care of your compact discs:
l Use only compact discs with the mark .
l Fingerprints, dust, and dirt should be carefully wiped off the disc’s
playing surface (shiny side) with a soft cloth. Wipe in a straight
motion from the inside to the outside of the disc.
l Never use chemicals such as record sprays, household cleaners
or thinner to clean compact discs. Such chemicals can
irreparably damage the disc’s surface.
l Discs should be kept in their storage cases when not in use.
l Do not expose discs to direct sunlight, high temperatures or high
humidity for extended periods.
l Do not stick paper, tape, or labels on the disc surfaces nor write
on them with any type of marker.
NOTES ON DISCS
Attempting to use non-standard shape discs (e.g.; square, star,
heart) may damage the unit. Be sure to use round-shape CDs only
in this unit.
ELECTRONIC SKIP PROTECTION (ESP)
The CD Player in this unit is equipped with Electronic Skip
Protection (ESP) circuits. This capability enables the CD Player to
project disc play approximately 10 seconds ahead of its current play
position. As a result, if a severe road bump is encountered during
Player operation, play of the current track will not be interrupted, or
result in a skip.
NOTES ON CD-Rs (Recordable CDs)/CD-RWs (Rewriteable
CDs):
1. Be sure to use discs with the following marks only for play
in this unit: .
2. The unit cannot play a CD-R or CD-RW that is not finalized.
(Please refer to the manual of your CD-R/CD-RW software
for more information on the finalization process.)
3. Depending on the recording status, conditions of the disc
and the equipment used for the recording, some CD-Rs/
CD-RWs may not be played on this unit.
RELIABLE PLAYBACK:
To ensure more reliable playback, please note the following
recommendations:
1. Use CD-RWs with speed 1x to 4x.
2. Use CD-Rs with speed 1x to 8x, and write with speed 1x to
2x.
3. Do not play a CD-RW which has been written on more than
5 times.
NOTES ON MULTI-SESSION DISCS:
If the first track of the first session is audio CD data, then the unit
will play only the audio CD data.